LPSR

The LPSR is a One-of driving simulator built around the LPSIMU 4 chassis. Its custom wheel, seat, paint and graphics give this project its own identity. The gallery shows 3D views of this LPSR project, including its custom driving position and finishes.

A cockpit designed as one complete piece

The custom steering wheel and seat are matched to the driving position. Anodised fasteners, bespoke paint and graphics carry the same visual theme across the cockpit.

Carbon, protection and cable routing

Carbon cladding conceals the cable routing, while XPEL protective film covers exposed finishes. These details keep the technical equipment discreet.

The selected driving setup

The configuration includes a Simucube 3 Pro Direct Drive base, Simucube ActivePedal Ultimate brake with Co-Pedal, a 57-inch Samsung display, an LP3 PC and D-BOX GEN5 motion hardware. LPSIMU checks the final specification with you before building.

Prepared with LPSIMU

We define the installation and finishes with you, then assemble, configure and test the simulator in our workshop. Delivery and on-site installation are quoted separately.

CREATE MY SIMULATOR

One-of project • configuration and quotation defined with you.

ONE-OF

A CLOSER LOOK AT LPSR

Every finish tells part of the story.

Designed around your project and prepared in our Graveson workshop.

01 / THE WHEEL

A WHEEL MADE FOR THIS PROJECT.

The custom wheel is the central point of contact with the simulator. Its design follows the driving position and finishes selected for this LPSR.

02 / THE SEAT

A DRIVING POSITION THAT FITS.

The custom seat completes the cockpit’s visual identity. Its position on rails is planned together with the wheel and pedals to create one coherent driving setup.

LPSR wheel support and anodised fasteners

03 / THE FASTENERS

FINISHED DOWN TO THE FASTENERS.

Red anodised fasteners accent the visible chassis components. These small details tie the technical parts to the project’s visual direction.

Rear equipment and carbon cladding on the LPSR

04 / CARBON AND PROTECTION

CABLES KEPT OUT OF SIGHT.

Carbon cladding hides the cable routing and gives the simulator a continuous finish. XPEL film is specified to protect exposed surfaces.

05 / THE PAINT

ONE PAINT FINISH FOR ONE SIMULATOR.

The custom paint gives the chassis its own colour. It is part of the overall composition, alongside the wheel, seat and anodised details.

06 / THE GRAPHICS

A PERSONAL VISUAL SIGNATURE.

Custom graphics complete the LPSR silhouette. Their lines are defined alongside the paint and other finishes for a clear identity from every angle.

A One-of simulator built around you.

01

Your own identity

Choose the wheel, seat, paint, fasteners and graphics together. Every decision becomes part of one coherent project.

02

A cockpit built around you

Driving position, controls, display and finishes are planned around how and where you will use the simulator.

03

A guided project

LPSIMU confirms the specification with you, then assembles, configures and tests the simulator before delivery.

ONE-OFF / YOUR PERSONAL TEAM

Your simulator. Your team.

Louis and Julien are your dedicated contacts as you shape your one-of-a-kind simulator. Christian follows your project through each step. Enzo and Maxime assemble and fine-tune it in our Graveson workshop. You know the people behind your build, from the first conversation to delivery.

Meet our team